![]() ![]() Here, the ramp signal is evaluated through the staircase signal, which is produced from the staircase generator. The signal which is generated from the ramp generator can be given to the voltage comparator unit. ![]() Once the sampling cycle starts, the oscillator will be switched ON through the trigger signals, so that linear ramp output voltage can be generated. When the vertical amplifier is used in the circuit, then it holdups the input signal & once the amplification of the signal is done then the signal can be given to the vertical plates. It is important that sampling can be done in synchronization through the frequency of the given input signal. Once the sampling signal is given to this sampling gate, then it will open to sample the input signal. From the above figure, we can notice that the input signal is applied to the sampling gate.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |